Catgenie Sanlution Hack Driver To Loosen

But opting out of some of these cookies may affect your browsing experience.

I had never taken my Catgenie apart as Scott did, but had built a small contact board instead.

This didnt work for some reason the controller never seems to receive any I2C commands from the Catgenie.

While I could read from and write to the chip using the Arduino, the Catgenie didnt like it.

It is powered by the Catgenie and so is fully self contained.

For the more technical minded, the Catgenie acts as an I2C bus master (providing a clock signal), and the cartridge acts as a slave.

There are four IO connections on the cartridge, each exposed through two of the connector terminals.

Lay the conductors flat on the terminals, and then solder them to the terminals, as shown in the pictures.

Catgenie Sanlution Hack Driver To Loosen

Use a small screw driver to loosen the catches on the side of the cartridge, and prise it apart carefully.

Make the holes in the top of the cartridge so that they are visible and accessible when the cartridge is inserted into the Catgenie.

Note that I used a glue gun to secure those wires as well to prevent their movement causing fatigue of my terrible soldering joints.

The process of doing this is straight forward, but is better explained by a more general guide.

If you are unfamiliar with the Arduino, I suggest reading the Getting Started guide, at.

You need to use the master mode when testing connected to the PCs USB, and slave mode when its running through the Catgenie.

To start with, use the standalone option, and upload it to your Arduino using the development environment.

There are three strips: 5v line, to connect the power from the Catgenie up to the Arduino and switch 0v line, to sink voltage from the LEDs and provide a common to the Arduino Switch line, which pulls the Arduinos input line down low when the switch is not depressed.

Connect the ground strip to the strip below it by soldering a 10K resister between the strips.

The other terminal pins should then be connected to new wires that connect to components or to the Arduino connectors.

I am using the Duemilanove, but the newer Uno or one of the smaller cheaper boards should be fine 2 x LEDs (eg.

Well assume youre ok with this, but you can opt-out if you wish.

Out of these, the cookies that are categorized as necessary are stored on your browser as they are essential for the working of basic functionalities of the website.

We also use third-party cookies that help us analyze and understand how you use this website.

These cookies will be stored in your browser only with your consent.

Catgenie Sanisolution Hack